Skip to content
KnxSolution.sk - KNX Future-proof technology
KnxSolution.sk - KNX Future-proof technology

86458618 DALI phase dimmer (front edge) 3-25W DT4

Original price €105,80 - Original price €105,80
Original price
€105,80
€105,80 - €105,80
Current price €105,80

Phase dimmer 86458618 with DALI control input (DT4)

Leading Edge Dimming (TRIAC dimming) uses a current that is turned off when the AC curve starts, just after it crosses zero. Leading edge dimming is typically used with incandescent lamps and creates a voltage surge every half cycle, resulting in a current surge into the light source.

Technical specifications:
Entrance: L, N
Input type: mains voltage
Identification terminals: L, N
Input voltage range: 230VAC
Mains frequency: 50Hz
Power consumption max.: 25W

Input: YES, YES
Input type: DALI control input, power supply
Identification terminals: DA, DA
Input voltage range: 9.5V to 22.5V
max current consumption DALI: 6mA
Number of DALI addresses: 1

Output: L, N
Output type: leading/trailing edge mains voltage
Identification terminals: L, N
Output voltage: 230VAC, same as input voltage
Start/end angle: 0 degrees to 180 degrees
Output voltage frequency: 50Hz, same as input voltage
Maximum output current: 0.2A rms AC
Output load range: 3-25W
Maximum device/bulb cable length: 50m

Insulation data:
Impulse voltage category: II
Nominal insulation voltage: 250V
Isolation DALI (DA+,DA-) / (L/N/L): Reinforced isolation
Insulation test voltage: 3000VAC

Environmental conditions:
Operating temperature: -20 to +60 degrees Celsius

General data:
Dimensions (LxWxH): 59x33x15mm
Installation: Integration into devices of protection class II
Maximum rated temperature: 65 degrees Celsius
Expected lifetime: 50,000 h
Protection class: II with proper installation
Enclosure degree of protection: IP40
Degree of protection of terminals: IP20

Terminals:
Connection type: spring clamp
Fixed connection capacity: 0.5 to 1.5 mm² (AWG20 to AWG16)
Connection capacity, fine wire: 0.5 to 1.5 mm² (AWG20 to AWG16)
Connection capacity with terminals: 0.25 to 1 mm²
Stripping Length: 8.5 to 9.5 mm / 0.33 to 0.37 inch
Release clamp: pressure mechanism

Information from the manufacturer

Estimated delivery time: 6 - 10 days